Allentown Infrastructure Group
Open-End Friction Pile
AIGBrochure trifold inside
AIGBrochure trifold outside
DESIGN | ENGINEERING | TESTING
The Open-End Friction Pile Products were designed, engineered, and field tested by an National Industry Leading Consulting Engineering and Scientific research firm. Their team conducted stringent field tests to verify and validate design values of the products
Time is Money Save Time on Critical Delivery Schedules
The Open-End Friction Pile is fabricated and assembled by Allentown Infrastructure Group. The piling is produced from the specific structural steel elements determined in the engineered design. Allentown Infrastructure Group is a member of AISC and operates under AISC procedures.
After galvanizing, the Friction Pile is assembled with each bolt is torqued to the-engineered 28 kips.
The Friction Pile scan be shipped via truck from Allentown Infrastructure Group in Pittsburgh to the job site.
INSTALLATION
The Open-End pile can be installed with a MobilRam, Hanging Vibratory Hammer from a Crane orExcavator.
Installation witha Hanging Vibratory Hammer -Crane
Installation with
a Hanging Vibratory Hammer–Excavator
Time Savings = Cost Savings
- FIG’s Open-End Friction Pile reduces the overall project schedule with new methods of installation.
- Friction Piles are installed with in hours and is immediately ready for structure erection.
- Friction Pile reduce man hours downtime & multiple mobilization.
Advantages of Friction Pile
- ZERO CONCRETE! No concrete is used for installing open ended friction pile.
- Ideal for limited access sites, congested areas, remote locations, and hazardous soils
- Friction Piles may be designed to allow the pile to be exposed accommodating terrain variations.
- Friction Piles are REMOVABLE and can be relocated.
Corrosion Protection
- All Products are Hot-Dipped Galvanized for corrosion protection.
- Cathodic protection is applied to the Friction Pile.
- Other high-tech coatings are available for protection in acidic soils.
US Patent Number 10,364,542
Contact Us
The designers then prepares shop-drawing to be used for fabrication and assembly of the product.
- 4315 Independence Dr, Schnecksville, PA 18078
- 412-913-5122